3D printing of biosourced and recyclable resin from 100% castor oil , glass, black brass
🌿 INSTRUCTIONS
1> Remove the two windows from the jewel by slightly shifting the vertical bar located at its top.
2> Place a few seeds at a distance of approximately 1 cm from the grid.
3> Place the potting soil provided, completely covering the seeds. Pack the soil and replace the windows.
4> During the germination phase: Make sure the soil is constantly moist. Water 1 to 2 times a day, passing your jewelry for several seconds under a stream of water. Leave the jewelry in a bright room but not in direct sunlight. Turn it over (glass against ground) so that the seedlings pass through the grid to seek the light. In a week maximum you will see your young shoots appear through the jewel grid.
5> Once the seeds have germinated...you can wear your jewelry! Remember to water it (about once a day, depending on the temperatures). When you are not wearing it, leave it in a bright room.
🌿 ARE YOU IN A RUSH?
Consider gently uprooting a small plant that you like, then replant it by passing the roots through the grid of your jewelry.
🌿 FOR MORE INSPIRATION FOLLOW US ON INSTAGRAM |TISTOU_BIJOUX| AND DON’T HESITATE TO CONTACT US!
